Get help with using AutoHotkey and its commands and hotkeys
3 posts • Page 1 of 1
I have some script that I run that has 3 variables. StartValue, EndValue and LocationValue. I usually go in and edit the script to change the values of all 3 of these variables. I stumbled across “Input” values that looks like it would do the job better but now I have seen information on GUI’s. I’m thinking this would be even better yet because I could keep the GUI screen on the window as to what my current values are and then it would be easier to reset the new values for the next time I run a script. I would like to put a button on the GUI to set the values after the 3 new values are entered. I’m finding a lot of samples in these forums that I can make work but they are much more elaborate than what I need to do and when I try to trim them down I’m doing something wrong and everything stops working.
So, what you want to do is make a GUI so you can change 3 variables? How's this?
If you want to make it look pretty, you can check out the documentation to figure out how to do that (basically just define x, y, width, and height for all the elements and the gui itself).
Code: Select all
StartValue := EndValue := LocationValue := 0 Gui, Add, Edit, vEdit1, start Gui, Add, Edit, vEdit2, end Gui, Add, Edit, vEdit3, location Gui, Add, Button,, Change Gui, Show,, Edit return ButtonChange: Gui, Submit StartValue := Edit1 EndValue := Edit2 LocationValue := Edit3 Gui, Destroy MsgBox % "Your variables are " StartValue ", " EndValue ", and " LocationValue return GuiClose: Gui, Destroy return
I have no idea what I'm doing.
Just what I needed!! Thanks for the help here.